Recent content by civil kumar

1. Prepare a bar bending schedule in order to classify different shapes of bars (bent up bar, straight anchor bar, eos bar, curtail bar etc) and diameters. 2. List down all the shapes of bars from the drawing. 3. Count the number of bars of each of those shapes. 4. Then calculate the cutting...

Simple, add wastage and recalculate if mix ratio is correct

steel 3% cement 2% sand 10% tiles 5% paints 2%

you get cement slurry pouches form RMC plant for pumping -pour , which is to be put in pump tray

Lapping should always be " Ld+300 " and must be staggered from adj. bar, in pic. lap is in tension zone which is wrong it's should be in compression zone i.e. in centre, remedy: use HILTI and increase lap-length for the short-rebars