Recent content by ranna

  1. R

    Which Analysis method we used in STAAD PRO to analyse the Structure?

    FINITE ELEMENT analysis IS BEING DONE IN STAAD PRO ANALYSIS
  2. R

    The reduction factor to the bearing capacity of a soil due to the water table at a depth equal to half of the width of the footing below the footing

    b
  3. R

    Brilliant Engineering - Would you construct such stair case

    THE LANDING SHOULD HAVE BEEN AT THE LINTEL LEVEL TO ACCOMMODATE ATLEAST A MAN HEIGHT
  4. R

    What is mean by 10/7 transit mixer

    The total/rated capacity of transit mixer is 10cum but the actual capacity to be carried is 7 cum allowing space(3 cu.m) for agitation/rotation
  5. R

    How to check the deflection of industrial chimney of around 40mt. height? Any IS code for the same?

    by theodolite you can measure
  6. R

    Steel Wrought iron is used for

    d
  7. R

    Admixtures The workability of concrete can be improved by the addition of the compounds of the following -

    a
  8. R

    How to setup Quality Control Lab at Project

    cement testing, concrete testing and aggregate testing equipments is a must for a lab
  9. R

    aerated bricks can be used for walls

    aerated bricks can be used for walls
    • ranna
    • Profile post comment
  10. R

    Any solution for such kind of rusted steel??

    Remove the rust in steel with rust remover and apply cement wash to rebars
  11. R

    which chajja has more flexural capacity ? why?

    As area of reinforcement provided is more in B. But development length provided in A is more w.r.t dia
  12. R

    what causes the failure of this structure

    Slender columns at ground floor level caused the failure This failure may be because of horizontal load due to wind/seismic No shear wall at ground floor level Reinforcement detailing would not have been done as per codal provisions
See more