Reinforced Concrete - MCQ

Dnyan Deshmukh
The maximum percentage of reinforcement in RCC pedestals is about -
Replies
1
Views
820
SKK
S
Dnyan Deshmukh
The minimum percentage of main reinforcement in RCC walls when it is not taken into load capacity is -
Replies
1
Views
769
SKK
S
Dnyan Deshmukh
The % increase in the allowable compressive stress in RCC walls whose height is more than twice the length of the wall is -
Replies
1
Views
777
SKK
S
Dnyan Deshmukh
The maximum spacing of longitudinal bars without a tie bent around alternate bars in RCC columns is -
Replies
1
Views
1,187
SKK
S
Dnyan Deshmukh
A RCC wall may be considered long for design purposes to give reduction in the load capacity if -
Replies
1
Views
746
SKK
S
Dnyan Deshmukh
The minimum % of the vertical reinforcement in RCC walls with deformed bars is -
Replies
1
Views
493
SKK
S
Dnyan Deshmukh
The design criterion in RCC walls is very similar to -
Replies
4
Views
3,227
SKK
S
Dnyan Deshmukh
The minimum straight-lap length in tension bars with hooks in RCC beams is -
Replies
7
Views
1,588
SKK
S
Dnyan Deshmukh
The permissible direct compressive stress on concrete in RCC columns is -
Replies
4
Views
1,778
SKK
S
Dnyan Deshmukh
In un-cracked reinforced concrete columns the actual bending compressive stress is obtained as -
Replies
5
Views
1,678
SKK
S
Srinivasan
Minimum spacing between horizontal parallel reinforcement of the same size should not be less than
Replies
3
Views
964
SKK
S
Dnyan Deshmukh
The minimum percentage of elongation of cold twisted steel bars should be about -
Replies
1
Views
519
SKK
S
Dnyan Deshmukh
The minimum percentage of elongation of hard drawn wires should be about -
Replies
1
Views
470
SKK
S
Dnyan Deshmukh
The allowable tensile stress in medium strength deformed bars used in reinforced cement concrete is -
Replies
1
Views
574
SKK
S
Dnyan Deshmukh
The allowable compressive stress in high yield strength deformed bars used in doubly reinforced cement concrete beams is -
Replies
1
Views
589
SKK
S
Dnyan Deshmukh
The ratio of the 15 cm cube strength to the permissible axial compressive stress in reinforced concrete is approximately equal to -
Replies
1
Views
724
SKK
S
Dnyan Deshmukh
For the purpose of design of RCC columns, a column is said to be short if the effective length to the least side ratio is less than -
Replies
1
Views
456
SKK
S
Dnyan Deshmukh
A cantilever column can be considered as a pedestal if the ratio of its height to the least side is -
Replies
1
Views
533
SKK
S
Dnyan Deshmukh
The maximum permissible slender column is RCC design is when the ratio of the effective height to the least side is less than -
Replies
1
Views
509
SKK
S
Dnyan Deshmukh
The minimum lap length at the splice of compression reinforcement in RCC is -
Replies
6
Views
1,467
Chandra Gopal Pandey
C
You must log in or register to post here.